- Brand: ALITOVE
- Power Source: DC
- Item Dimensions LxWxH: 4.72 x 1.57 x 1.18 inches
- Mounting Type: Tabletop
- Current Rating: 5 Amps
- Input: 100V-240V 50/60Hz; Output: DC 12V 5A max; Output adaptor jack size: 5.5mm x 2.5mm,compatible with 5.5mm x 2.1mm
- Safety features: Automatic overload cut-off, over Voltage cut-off, automatic thermal cut-off, short circuit protection.
- Voltage consistency: There is no voltage fluctuations at power on, during transmit, receive, or at power off. It will protect your electronic products from destruction.
- It comes with a free female DC connector. So you can easily connect wires on it without soldering.
- Great for LED Strips, 3D Printer, ham radio transceiver, CCTV cameras๏ผcar subwoofer amp, audio amplifier, wireless router, ADSL Cats, HUB, audio/ video power supply. Indoor use only!





















![Top 10 โญ 2 Pack - SnapPower GuideLight 2 For Outlets [New Version - LED Light Bar] - Night Light - Electrical Outlet Wall Plate With LED Night Lights - Automatic On/Off Sensor - (Duplex, White) ๐](https://www.walllampstore.com/wp-content/uploads/2022/12/31Cr0vHcjHL-247x247.webp)

JohnT –
It’s 12 volt 5 amp as advertised, the output isn’t clean enough for a Radio, it says it has a ton of features, like limit shutoff and over heat. If that’s true you could charge batteries to power a Radio.I run my 2way off deep cycle my search is set at .4 this power supply makes me set the threshold at 2.0
Greg –
Very clean and grounded power supply. I used this on an FM transmitter to eliminate โnoiseโ from a PA system aux out to the transmitter. Original supply had no earth ground, shielding or low voltage ferrite core that this unit does have.
Polly Spence –
We bought these for our inflatable Halloween yard decorations as the ones that had come with them had died. These worked perfectly and our decorations look great again!
Jesse L. –
Is perfect for whatever project of 12 VDC 2 amps to 5 amps like surveillance cameras, external HDD, NAS power supply, etc. Happy so far
Darb –
Used with linear motor works fantastic
Fernando –
No more flickering (previous 2A power supply was not able to sustain the LEDs at 100% brightness). This power supply solved the issue.
Randolph Wells –
I have found nothing negative about this unit. I am using this to power a motorized valve. So far so good.
sophie –
Needed it for my fish tank light. It works correctly but the box housing unit gets too hot